| Part | Label | Function | |------|-------|----------| | Laser emitter | (Front lens) | Emits the targeting beam | | Laser receiver | (Adjacent small lens) | Detects reflected beam | | LCD display | (Top digital screen) | Shows measurements, mode, battery status | | Power/Measure button | (Green/Red, center) | Press to turn on; press to measure | | Mode button | (M) | Cycles between measurement units (ft/in, decimal ft, meters) | | Reference button | (REF) | Switches between front-end and back-end measurement | | Clear/Off button | (C/OFF) | Clears last reading; hold to power off | | Battery compartment | (Rear bottom slide cover) | Houses the 9V battery | | Wrist strap loop | (Left side) | For attaching the included strap |
For the memory functions, perhaps there's a button to save measurements, recall them, or totalize multiple measurements. Battery information might mention CR2032 batteries, replacement, and charging if it's rechargeable.
| © 2026 Point-N-Measure Tools
Now that we've covered the introduction and key features, let's move on to the user manual.
Compact, pocket-sized design weighing approximately 4 ounces. How to Use (Standard Operation) Based on similar models and seller descriptions: Point-N-Measure Digital Tape W5746 User Manual
This post is formatted for a knowledge base, product listing (Amazon, Home Depot), or a support page.
Press the REF button. The icon on the LCD changes from a front arrow to a back arrow. | Part | Label | Function | |------|-------|----------|
This is crucial. Decide if you want to measure from the front of the device or the back (base). Look for the icon on the screen—measuring from the back is best for wall-to-wall distances. 📏 How to Measure Like a Pro The W5746 offers three main modes to handle any job:
