Mitsubishi Tension Controller Le 30 Cta Manual ~repack~ Jun 2026

The LE-30CTA operates by receiving signals from tension detectors (load cells). It compares this actual tension against a user-defined setpoint. To maintain balance, it outputs a control signal (typically 0–24V DC or 0–10V) to regulate the torque of the driving or braking element.

Perform single-point grounding on the controller side of the shielded cable. Manual Resources mitsubishi tension controller le 30 cta Manual

Production for the LE-30CTA was discontinued as of March 2024 . The official successor model recommended by Mitsubishi Electric is the LE7-40GU-L . 2. Technical Specifications Feature Power Input I/O Points 32 input/output mixed points Output Type Transistor output (source type) Rated Output Voltage DC 12V to 24V Max Load Current 0.1A per point 3. Installation & Safety Guidelines The LE-30CTA operates by receiving signals from tension

The LE-40MTA is the direct form-fit successor. It uses the same 50-pin connector and sensor technology. The programming logic is similar, but the manual is newer. You can often swap in 30 minutes. Perform single-point grounding on the controller side of

Keep control lines at least away from main power lines to avoid noise-induced malfunctions.

The following are the technical specifications of the Mitsubishi Tension Controller LE-30 CTA: